About the Version of Program Card

In August 2020, a new version of program card, called Program Card X, was introduced to replace the previous one. The new program card X uses a 32-bit MCU and an external EEPROM with larger capacity which make it possible to be used for more devices in the future. Furthermore, the new program card X can work at a wider voltage range (4.8V to 8.4V) direclty without being reliant on the gyro. Therefore, it is recommended to use the program card X for our later gyros such as A3 Mini, A3 Super 4, ect.

Also please note that due to the voltage limitation of the old program card, always limit the working voltage of the gyro below 5.5V when using it for A3 Mini or A3 Super 4, or it may cause connection to fail or even damage of the card.

Before updating the card, always distinguish the version of yours and choose the correct firmware. Below are the release notes of both the new Program Card X and the previous program card for your reference.

Program Card X Update Notes

Firmware Name
Update Time
Changes & Notes
Size

Program Card X Firmware V1.3
for the newest "X" hardware NEW
2022-04-17
  • JETI EXBus option added to the receiver list of A3S4 and A3 Mini.
  • Other minor fixes and improvements.
35.0KB
Program Card X Firmware V1.2
for the newest "X" hardware
2022-03-27
  • A3 Super 4 support added, compatible with A3 Mini and A3 Super 3 (F/W V2.x).
  • Channel mappings reset and gyro restart confirmation added after changing the receiver type.
  • "DSM Binding Option" added in the receiver menu of A3 Mini.
  • Other minor fixes and improvements.
34.6KB
Program Card X Firmware V1.1
for the newest "X" hardware
2021-12-07
  • A3 Mini support added.
  • Compatible with A3 Super 3 (F/W V2.x).
30.3KB
Program Card X Firmware V1.0
for the newest "X" hardware
2021-06-12
Program Card X Initial Version.
27.7KB

Program Card Update Notes

Firmware Name
Update Time
Changes & Notes
Size

Program Card Firmware V5.0
for the older hardware NEW
2022-04-30

Changes

  • A3 Super 4 support added.
  • Channel mappings reset and gyro restart confirmation added after changing the receiver type.
  • Other minor fixes and improvements.

Notes

  • Due to the capacity limitation of the old program card, this version has been divided into 3 update packages in which each firmware supports only 2 devices, please choose according to your needs.
  • Due to the voltage limitation of the old program card, always limit the working voltage of the gyro below 5.5V when using for A3 Mini or A3 Super 4, or it may cause connection to fail or even damage of the card!
30.1KB
Program Card Firmware V4.1
for the older hardware
2021-12-21
  • A3 Mini support added.
  • Compatible with A3 Super 3 (F/W V2.x).
27.2KB